First, the product description ??? a stainless steel tank is fiberglass tanks after a new generation of tanks, and its products SUS304 stainless steel plate precision molded, handsome in appearance, economical and practical, subject to eventually becoming worse. ?? 2, stainless steel tanks compared to other tanks, light weight, high strength, corrosion resistance, high temperature, clean water, seepage, seismic, never moss, easy installation, no maintenance, easy to clean, and many other advantages. ?? 3, stainless steel water tanks are common square modular tank. Adopted SUS304, SUS316L, SUS444 and other stainless steel plate, stamping, surrounding by TIG welding of high strength, light weight, low cost, environmental health and other characteristics. Manufacturing standards for the National Building Standard Design Atlas 02S101. ? Second, product characteristics ??? 1, stainless steel tanks commonly used material SUS304 stainless steel sheet, stable physical and chemical properties of water pollution, ensure clean water quality. ?? 2, stainless steel tanks stamping molding, high strength, light weight, looks clean, beautiful and elegant. ?? 3, water boards are generally high nickel above 8.0 3042B board, smooth surface appearance, easy to clean. ?? 4, due to the dense surface oxide layer, excellent corrosion resistance, good sealing performance. ?? 5, big impact performance, strong seismic performance. ?? 6, square stainless steel water tank can be assembled from O.5T-2000T, and based on customer needs to undertake various types of special production. Third, the technical requirements and parameters ?? 1, to the water tank weld material: According to the press following the use of the preparation of the technical parameters of stainless steel water tank, water tank accessories ordinary carbon steel material and type just the production, LB304NI8.0 type electrode welding, and its quality should be separately the current standard "carbon steel" and "steel rod" requirement. ? 2, tank top, tank wall, floor mosaic of LB304 are made of stainless steel butt weld (as I type seam roof, floor and sidewalls for V-seam), other welding of fillet welds, the weld between does not allow cross phenomenon, and may not coincide with the ribs, welder for LB-2-300 stainless steel tanks dedicated welder with welding and TIG welding function 3, full of water experiment:? tank production is finished, the water tank completely filled with water, after 2 to 3 hours, with a heavy hammer on both sides along the lead from 0.5 to 1.5 kg of approximately 150 mm of the weld where tapping, watertight as acceptable if found to have the leak, to be re-welded, and then the experiment .